Canthopexy or Canthoplasty: What Changes at the Corner
A canthopexy tightens or suspends the outer corner tendon while it stays attached to the bone. A canthoplasty divides that tendon and fixes it to a new point. That difference decides almost everything else: how predictable the result is, how the two sides are matched, how long healing takes, and which decisions you still hold afterwards.
The Short Version
Canthopexy leaves the tendon's own bony attachment intact and changes its tension or its support.
Canthoplasty detaches the tendon and reattaches it at a chosen point on the orbital rim.
A canthopexy preserves the option of a canthoplasty later. A canthoplasty removes the option of going back to an untouched tendon.
Symmetry works differently in each: one corner is still anchored where anatomy put it, the other is anchored where the surgeon put it.
Both are planned with you sitting upright, not lying on the table, because the corner's apparent height changes with head position.
Op. Dr. Fatma Soysüren performs canthopexy and canthoplasty as part of facial aesthetic surgery in Istanbul, as an ENT surgeon with more than 4,000 facial aesthetic procedures behind her.
Why "which one is better" is the wrong question
Most pages on this subject compare the two operations as if they were two settings of one dial, canthopexy mild and canthoplasty strong. They are not related that way. One works with the tendon's existing attachment; the other replaces that attachment with a new one.
So the question is not which is stronger. It is whether your outer corner needs its tension changed or its position changed — two separate findings the examination can tell apart before any technique is named.
Patients usually arrive having read both words and chosen one. The sentence we hear most often is: "I think I need the stronger one." Almost always the examination has not yet been done.
What a canthopexy does to the tendon
In a canthopexy the lateral canthal tendon stays joined to the bone. What changes is its tension or the support underneath it: the tendon is shortened, folded on itself, or suspended higher with a stitch that anchors into the periosteum above its own insertion.
The corner moves, but it moves while remaining tethered at its original point. That tether limits how far the corner can travel, which is the honest reason canthopexy produces smaller changes. It is also why the result tends to settle where it was placed, with less drift during healing.
What a canthoplasty does to the tendon
In a canthoplasty the tendon is divided from its attachment. Once it is free, the corner can be placed almost anywhere the lateral orbital rim allows, and it is held there by a stitch into the periosteum at the new height. Nothing is pulling it back towards the old position.
That is why canthoplasty can produce a change a canthopexy cannot: the limiting factor is no longer the tendon's own anchor. It is also why the operation is less forgiving. The new position is created rather than adjusted, and a created position has to be read correctly before it is fixed.
One operation preserves a decision, the other spends it
A tendon that is still attached can later be detached. A tendon that has been detached and healed into a new place cannot be returned to an untouched state. The tissue plane around it has scarred, and the original insertion is no longer a clean landmark.
It is the same logic we use for upper eyelid skin: the first operation has the most options, so it should not be the one that uses them all up. When the examination shows that tension alone explains the complaint, we do the operation that leaves the other door open.
Reversible and revisable are not the same word
Neither operation is reversible. A canthopexy stitch can stretch or a fold can relax, which is a change but not a return. What differs is how easily each can be revised, and that difference has an anatomical reason rather than a technical one.
Revising a canthopexy means working on a tendon that is still where it belongs. Revising a canthoplasty means finding a tendon that healed where it was placed, in a field that already has scar in it. Both are done; one is simply a shorter conversation at the second examination. Patients are told which of the two they are choosing before anything is marked.
Two corners, two separate decisions
The eyes are rarely symmetrical before surgery, and the outer corners are usually the least symmetrical part of the eyelid region. Asymmetry is read as an address, not as a single number.
In a canthopexy both corners keep their own anchors, so a small original difference stays small and often passes unnoticed. In a canthoplasty both corners are placed, and the two placements have to agree in height and in angle. That is the harder task, and it is why bilateral canthoplasty is marked, checked and re-checked with the head upright rather than measured once.
Healing runs on two different clocks
A tightened tendon is a tendon under new tension, and that tension settles within weeks. A divided tendon has to heal to periosteum, and periosteal healing is measured in months. The corner can look correct on the second week and still move slightly as that attachment matures.
Swelling behaves differently too. The lateral canthal region drains slowly, so the outer third looks fuller and rounder in early photographs than it will at six months. We do not judge corner height before the third month in a canthopexy, or before the sixth in a canthoplasty.
The bone decides more than the stitch
The lateral canthal tendon anchors to a small ridge on the inner surface of the lateral orbital rim — the same bone a facial surgeon works on from the other direction in orbital approaches, where this tendon is routinely detached at the start of the operation and reattached at the end.
Working on that bone regularly teaches one thing that matters here: the final height of the corner is decided by where on the periosteum the tendon is anchored, not by how tight the stitch is. A tight stitch at the wrong height gives a tense corner at the wrong height. This part of the assessment is routine daily work in ENT surgery, where the lateral orbital rim is a familiar landmark rather than an unfamiliar one.
How the corner height is chosen before anything is divided
The position is marked with you sitting upright, eyes open, forehead relaxed — because lying down raises the outer corner by a few millimetres on its own, and a height marked on the table is a height measured in the wrong posture. Brow position is checked in the same sitting, since a heavy brow tail changes what the corner appears to be doing.
Then, before the tendon is divided in a canthoplasty, the intended position is held temporarily with a traction stitch that can be released. You sit up and the corner is read at the planned height. If the read is wrong, the stitch comes out and a different height is chosen while the tendon is still attached. The irreversible step happens after the position has been seen, not before.
What is not promised, and which corners wait
Millimetric symmetry is not promised, and an assessment that commits to an exact corner height on a photograph is estimating rather than measuring.
What is given instead is a range, the posture the result was planned in, and the reason that range was chosen for your lower lid support. Some corners wait: an untreated dry eye, a negative-vector midface where lifting the corner would widen the scleral gap, and a lower lid that fails the snap-back test all mean the corner is not the first problem to solve. In those cases the lid support and the surface are dealt with first, in our own clinic, and the corner is re-measured afterwards. Rapid weight loss also thins the skin over the corner within months, so the measurement is repeated rather than assumed. Who the almond-eye appearance suits is set out in our earlier piece on candidacy.
The outer corner is rarely the only finding. Upper lid skin, lid height and brow position are written on the same page as the corner, because changing one of them changes what the others appear to do. That whole-region reading is the basis of our approach to eyelid surgery and to facial rejuvenation generally. For patients travelling, the question worth asking from home is whether the plan names a finding for every step; why patients choose Istanbul and how Dr. Fatma Soysüren works are set out separately.
Frequently Asked Questions
Is a canthopexy always the safer choice?
It is the less committing choice, which is not the same thing. If the finding is a corner sitting too low rather than a corner that is merely lax, a canthopexy will not reach it and the result will look under-corrected.
Can a canthoplasty be converted back to a canthopexy?
No. Once the tendon has been divided and reattached, there is no untouched tendon to tighten. A second canthoplasty is possible; a return to the original anatomy is not.
Will the corner look the same on both sides?
The aim is that the difference is below the threshold at which it is noticed, roughly three to four millimetres in the eyelid region. Exact equality is not promised, because the two sides rarely start equal.
How long before the final corner shape is visible?
About three months after a canthopexy and about six after a canthoplasty. The outer third of the lid holds fluid longest, so early photographs show a rounder shape than the settled result.
Can either operation be combined with eyelid surgery?
Both are routinely planned together with upper or lower lid surgery, and the corner is usually addressed last in the same operation so the lid is already in its new position when the height is set.
Is the scar visible?
The incision follows the lateral canthal line into an existing crease at the corner. It is short, and in most patients it settles to a fine line by the sixth month, though scar behaviour depends on skin type.
Deciding which of the two applies to you
The decision is not made from a photograph, and not from a preference. It is made from two findings at the examination: whether the tendon is lax, and whether the corner is low. The first answers to tightening, the second needs repositioning. When both are present, the sequence matters more than the technique name.
If you are weighing this up, ask which of those two findings your plan is based on, and what posture the corner was measured in. A plan that answers both is one you can compare with any other.
We perform all treatments at our partner hospitals and clinics which have health tourism licenses and authority.
Comments